Instructions temporary boiler

Installation instructions (for disconnection instructions, scroll down)

Please read in full before starting. Do not plug in the electricity yet.

Place in upright position, next to the shower screen.
Temporary boiler with lid opened.
Accessoires.
Remove the current shower hose and head.
Place our shower head in your own shower holder.
Screw on the Gardena tap connector
click the hose on, like on the picture.
Attach the other end of our hose to the temporary boiler, like on the picture.
Put the temperature of the faucet higher.
Now open the faucet, on the left side.
Open your own shower faucet. This has to be open during useage of the boiler.
The boiler will now fill up. When you get a steady stream, the boiler is full. It might take a few minutes. When the boiler is filled, you can shut off the faucet on the temporary boiler.
Don't forget to turn the faucet back to 38 or so degrees. From now on you use our faucet to turn on the water.
Only now you can plug the boiler in. Let it heat for 45 minutes. Then, keep it plugged in and leave 20 minutes between showers.
! When not using the shower, shut off your own faucet!

Disconnecting the boiler

First, take out the electricity plug.
Shut off your own faucet
Open the boilers' faucet and let it drain out for a moment. Then close it again.
Unscrew the hose at this connection and let the hose drain out into the shower. You can lift the hose higher to help all the water out.
Put the temporary boiler flat. Unscrew the hose connection in the right bottom.
Screw the lid (with rubber ring) back on. Hand tight.
Place all accesoires back into the box.
These are all accessoires that need to be put back. Make sure the grey Gardena tap connector is also in.
You can put the boiler back in upright position now.
Do not foget the grey connector (incl. rubber ring) from your tap! Click it back into the Gardena part.